Ryobi RY43160A Manuel de l'opérateur télécharger pdf (Page 12)

Page 12 — English

Fig. 4

CHAIN

LUBRICANT

OIL

RESERVOIR

CAP

QUICK VIEW

OIL INDICATOR

DANGER:

Never cut near power lines, electric cords, or

other electric sources. If bar and chain jams

on any electrical cord or line, DO NOT TOUCH

THE BAR OR CHAIN! THEY CAN BECOME

ELECTRICALLY LIVE AND VERY DANGEROUS.

Continue to hold the pole saw by the insulated

rear handle or lay it down and away from you in

a safe manner. Disconnect the electrical service

to the damaged line or cord before attempting

to free the bar and chain from the line or cord.

Contact with the bar, chain, other conductive

parts of the pole saw, or live electric cords or

lines will result in death by electrocution or seri-

ous injury.

WARNING:

Do not allow familiarity with this product to make

you careless. Remember that a careless fraction

of a second is sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields

marked to comply with ANSI Z87.1, along with

head protection. Failure to do so could result in

objects being thrown into your eyes and other

possible serious injuries.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product.

The use of attachments or accessories not recom-

mended can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed

below:

 Limbing

 Pruning

ADDING BAR AND CHAIN LUBRICANT

See Figure 4

Use Bar and Chain Lubricant. It is designed for

chains and chain oilers, and is formulated to

perform over a wide temperature range with no

dilution required.

NOTE: Pole saw comes from the factory with

no bar and chain oil added. Level should also be

checked after every 20 minutes of use and refilled

as needed.

Remove oil cap.

Carefully pour the bar and chain oil into the

tank.

Wipe off excess oil.

Check and fill the oil tank when quick view oil

indicator is below the second to last indicator

line.

Repeat as needed.

NOTE: Do not use dirty, used or otherwise

contaminated oils. Damage may occur to the

bar or chain.

NOTE: It is normal for oil to seep from the saw

when not in use. To prevent seepage, empty the

oil tank after each use then run for one minute.

When storing the unit for a long period of time

(three months or longer) be sure the chain is lightly

lubricated; this will prevent rust on the chain and

bar sprocket.

OPERATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY43160A Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Ryobi RY43160A