Ryobi RY43160A Manuel de l'opérateur télécharger pdf (Page 13)

Page 13 — English

CONNECTING TO POWER SUPPLY

See Figure 5.

This product is designed with a cord retainer that

prevents the extension cord from being pulled

loose while using.

Form a loop with the end of the extension

cord.

Insert loop portion of extension cord through

opening in the bottom of the rear handle and

place over cord retainer.

Slowly pull loop against cord retainer until the

slack is removed.

Plug product into extension cord.

NOTE: Failure to remove all excess cord slack

from extension cord retainer could result in plug

loosening from receptacle.

STARTING AND STOPPING

See Figure 5.

To start the motor:

 Connect the pole saw to power supply.

 Place your thumb on the lock-out button and

pull it completely towards you.

 Fully depress the switch trigger.

To stop the motor:

 Release the switch trigger.

Fig. 5

LOCK-OUT

BUTTON

SWITCH TRIGGER

CORD RETAINER

ADJUSTING TELESCOPING POLE

See Figure 6.

 Disconnect the pole saw from the power sup-

ply.

 Rotate the collar counterclockwise to loosen.

 Push poles towards each other to shorten the

pole or pull away from each other to lengthen

the pole.

NOTE: Extend the pole only to the length

required to reach the limb being cut. Do not

extend the handle above waist height.

 When the desired length is achieved, rotate the

collar clockwise to secure.

NOTE: Adjust hand placement on the shaft of the

pole saw to keep proper balance. Do not attempt

to use the pole saw at a length which does not

allow you to achieve proper footing and balance

at all times.

OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY43160A Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Ryobi RY43160A