Ryobi RY43160A Manuel de l'opérateur télécharger pdf (Page 15)

Page 15 — English

Fig. 9

60° MAXIMUM

Fig. 10

LIMBING AND PRUNING

See Figures 9 - 10.

This unit is designed for trimming small branches

and limbs up to 6 in. in diameter. For best results,

observe the following precautions.

 Plan the cut carefully. Be aware of the direction

in which the branch will fall.

 Branches may fall in unexpected directions. Do

not stand directly under the branch being cut.

 The most typical cutting application is to posi-

tion the unit at an angle of 60° or less, depend-

ing on the specific situation, as shown. As the

angle of the pole saw shaft to ground increases,

the difficulty of making the first cut (from the

underside of limb) increases.

 Remove long branches in several stages.

 Cut lower branches first to allow the top branch-

es more room to fall.

 Work slowly, keeping both hands on the saw

with a firm grip. Maintain secure footing and

balance.

 Keep the tree between you and the chain while

limbing. Cut from side of tree opposite branch

you are cutting.

 Do not cut from a ladder; this is extremely

dangerous. Leave this operation for profes-

sionals.

 Do not make the flush cut next to the main limb

or trunk until you have cut off the limb further out

to reduce the weight. Following proper cutting

procedures will prevent stripping the bark from

the main member.

 Do not use the pole saw for felling or bucking.

 To prevent electrocution, do not operate within

50 ft. of overhead electrical lines.

 Keep bystanders at least 50 ft. away.

OPERATION

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Pas de commentaire

Ryobi RY43160A Manuel de l'opérateur Page 15