Ryobi CTH1202K2 Manuel de service télécharger pdf (Page 17)

--- 14 ---

(iii) Install Washer (B) [23] in the Rear Case [14] with the projections of Washer (B) [23] engaged with the

recesses in the Rear Case [14], and turn Washer (B) [23] clockwise until it can turn no further. (See

Fig. 10.)

Fig. 10

Recess

Projection

[23]

(i) Insert the projection of the Click Spring [8] into the hole of the Front Case [9].

(ii) Mount the Cap [4].

Mount the Nut [5] into the Cap [4] engaging the wider projection of the Nut [5] with the wider recess of

the Cap [4]. (The wider recess of the Cap [4] is positioned at "1" when viewed from the outside.)

(iii) Apply grease (Hitachi Motor Grease No. 29, Code No. 930035) to the sliding surfaces of the Cap [4]

and the Click Spring [8].

Fig. 11

Cap [4]

Click Spring [8]

Hole

Pro-

jection

Wider recess

"1"

Recesses

Cap [4]

Nut [5]

Wider projection

Nut

Projections

(d) Install the Shift Arm [16] into the assembly reassembled in step (c).

With the ridge at the Shift Arm [16] facing the Motor [25] side, first install them on the unmarked side of the

assembly reassembled in step (c). Then insert the projections on the Shift Arm [16] into the holes in the

Rear Case [14] and make sure that the projections are fitted into the grooves in the Slide Ring Gear [17]

mounted within the Rear Case [14]. (See Fig. 12.)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

Ryobi CTH1202K2 Manuel de service Page 17