Ryobi CTH1202K2 Manuel de service télécharger pdf (Page 18)

--- 15 ---

(e) Install the Drill Chuck [2].

Install the Drill Chuck [2] using the special repair tool (J-292, Code No. 316379) and secure it with the

Special Screw (Left Hand) M5 x 35 [1].

(f) Install the Shift Knob [37] into the assembly reassembled in step (e).

When installing the Shift Knob [37] into the Shift Arm [16], note that the "LOW" mark on the Shift Knob [37]

faces the Motor [25] with the Shift Arm [16] engaged with the recess in the Shift Knob [37].

(g) Install the assembly reassembled in step (1) and the assembly reassembled in step (f) together. (See Fig.

13.)

Fit the projection on the Motor Spacer [24] into the recess in the Rear Case [14] while ensuring that the

Shift Knob [37] is aligned with the positive side of the Motor [25] and turn the Motor Spacer [24] clockwise

when viewed from the rear of the Motor [25] until it can turn no further. During installation, make sure that

the pinion press-fitted onto the shaft of the Motor [25] and Planet Gear (A) [21] mesh properly.

Fig. 12

[16]

Ridge

[16]

Hole

Groove

Mark

Fig. 13

(4) Installation of the Bit Holder [28] into Housing (B) [31]

Fit the upper and lower projections of the Bit Holder [28] in the grooves in Housing (B) [31].

(5) Installation of the assembly reassembled in step (3) into Housings (A) and (B) [31]

(a) Install the Pushing Button [36] into Housing (B) [31]. (See Fig. 14.)

(b) Install the assembly reassembled in step (3) into Housing (A) [31]. Note that the projections on the Front

Case [9] and the Motor Spacer [24] are engaged in the recesses in Housing (A) [31], and the projection on

Housing (A) [31] is engaged in the groove of the Cap [4]. (See Fig. 15.)

Projection

Recess

1 2 ... 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

Ryobi CTH1202K2 Manuel de service Page 18