Ryobi P205 Manuel de l'opérateur télécharger pdf (Page 9)

 − English

Fig. 2

BATTery PACK

lATChes

dePress lATChes

To releAse BATTery PACK

OPERATION

WARNING:

Battery tools are always in operating condition. There-

fore, switch should always be locked when not in use or

carrying at your side.

SWITCH TRIGGER

See Figure 3.

To turn the drill ON, depress the switch trigger. To turn it

OFF, release the switch trigger.

VARIABLE SPEED

The switch trigger delivers higher speed and torque with

increased trigger pressure and lower speed with decreased

trigger pressure.

NOTE: You might hear a whistling or ringing noise from the

switch during use. Do not be concerned; this is a normal

part of the switch function.

DIRECTION OF ROTATION SELECTOR

(FORWARD/REVERSE/CENTER LOCK)

See Figure 3.

The direction of bit rotation is reversible and is controlled

by a selector located above the switch trigger. With the drill

held in normal operating position, the direction of rotation

selector should be positioned to the left of the switch trigger

for drilling. The drilling direction is reversed when the selector

is to the right of the switch trigger.

Setting the direction of rotation selector in the OFF (center

lock) position helps reduce the possibility of accidental start-

ing when not in use.

CAUTION:

To prevent gear damage, always allow the chuck to

come to a complete stop before changing the direction

of rotation.

To stop the drill, release the switch trigger and allow the

chuck to come to a complete stop.

NOTE: The drill will not run unless the direction of rotation

selector is pushed fully to the left or right.

Avoid running the drill at low speeds for extended periods

of time. Running at low speeds under constant usage may

cause the drill to become overheated. If this occurs, cool the

drill by running it without a load and at full speed.

KEYLESS CHUCK

See Figure 3.

The drill has a keyless chuck to tighten or release drill bits

in the chuck jaws. Grasp and hold the collar of the chuck

with one hand. Rotate the chuck body with your other

hand. The arrows on the chuck indicate which direction

to rotate the chuck body in order to LOCK (tighten) or

UNLOCK (release) the drill bit.

WARNING:

Do not hold the chuck body with one hand and use the

power of the drill to tighten the chuck jaws on the drill

bit. The chuck body could slip in your hand, or your

hand could slip and come in contact with the rotating

drill bit. This could cause an accident resulting in serious

personal injury.

Fig. 3

reVerse

unloCK

(releAse)

loCK

(TighTen)

ChuCK

Body

ChuCK

CollAr

direCTion oF roTATion seleCTor

(ForwArd/reVerse/CenTer loCK)

ForwArd

swiTCh

Trigger

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Ryobi P205 Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Perceuses électriques Ryobi P205