Ryobi CDI-1801M Spécifications télécharger pdf (Page 7)

English

OPERATION

ADJUSTING THE DEPTH GAUGE ROD (Fig. 4)

Follow these steps to adjust the depth gauge rod.

■ Lock the trigger switch by placing the rotation selector

in the center position.

■ Loosen the auxiliary handle by turning the knob

counterclockwise.

■ Adjust the depth gauge rod so that the drill bit

extends beyond the end of the rod to the required

drilling depth.

■ Tighten the auxiliary handle by turning the knob

clockwise.

ADJUSTING THE TORQUE (Fig. 5)

The tool is equipped with an adjustable torque clutch for

driving different types of screws into different materials.

Adjust the torque as necessary.

We recommend that you use carbide-tipped bits and

select impact mode when drilling in hard material such as

brick, tile, concrete, etc.

CAUTION

The impact drill is not designed for reverse

hammering. Failure to obey this caution may

result in property damage.

SWITCH (Fig. 6)

■ To turn your drill ON, depress the switch trigger.

■ To turn it OFF, release the switch trigger.

VARIABLE SPEED

This tool has a variable speed switch that delivers higher

speed and torque with increased trigger pressure. Speed

is controlled by the amount of switch trigger depression.

SWITCH LOCK (Fig. 6)

The switch trigger can be locked in the OFF position. This

feature can be used to prevent the possibility of

accidental starting when not in use. To lock switch trigger,

place the direction of rotation selector (Forward/Reverse

Selector) in center position.

Note: When selector is in center position, switch trigger is

locked.

REVERSIBLE (Fig. 6)

This tool has the feature of being reversible. The direction

of rotation is controlled by a selector located above the

switch trigger. With the drill held in normal operating

position, the direction of rotation selector should be

positioned to the left of the switch for drilling. The drilling

direction is reversed when the selector is to the right of the

switch. When the selector is in center position, the switch

trigger is locked. To stop, release switch trigger and allow

the chuck to come to a complete stop.

ELECTRIC BRAKE

This drill has an electric brake. When the trigger switch is

released, the chuck stops turning. When the brake is

functioning properly, sparks will be visible through the

vent slots on the housing. This is normal and is the action

of the brake.

OPERATION

ADJUSTING THE SPEED (Fig. 8)

Follow these steps to adjust the speed.

■ For high speed: Slide the two-speed gear train switch

to “2.”

■ For low speed: Slide the two-speed gear train switch

to "1."

Note: If you have difficulty changing from one gear

range to the other, turn the chuck by hand until the

gears engage.

CAUTION

To prevent gear damage, always allow chuck to

come to a complete stop before changing the

speed or the direction of rotation.

KEYLESS CHUCK (Fig. 7)

Your drill has a keyless chuck. As the name implies,

you can hand tighten or release drill bits in the

chuck jaws. Rotate the chuck with your hand. Rotate the

chuck body with your other hand. The arrows on the

chuck indicate which direction to rotate the chuck body in

order to LOCK (tighten) or UNLOCK (release) the drill bit.

WARNING

Do not hold chuck body with one hand and use

power of the drill to tighten chuck jaws on drill bit.

Chuck body could slip in your hand or your hand

could slip and come in contact with rotating drill bit.

This could cause an accident resulting in serious

personal injury.

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

Ryobi CDI-1801M Spécifications Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Clés à chocs Ryobi CDI-1801M