Ryobi P234G Manuel de l'opérateur télécharger pdf (Page 9)

9 — English

OPERATION

BUILT-IN COUPLER

See Figure 4, page 11.

The tool has a built-in coupler. The coupler has been de-

signed to accept 1/4 in. hex bits.

INSTALLING BITS

See Figure 4, page 11.

 Lock switch trigger on the tool by placing the direction

of rotation selector in center position.

 Slide the coupler forward and hold in position.

 Insert bit straight into coupler.

 Slide the coupler back slowly and release.

REMOVING BITS

See Figure 4, page 11.

 Lock switch trigger or the drill by placing the direction of

rotation selector in center position.

 Slide the coupler forward and hold in position.

 Pull bit straight out of coupler.

WARNING:

Make sure the bit is secured in the coupler before using

the impact driver. Failure to do so could cause serious

personal injury.

WARNING:

Do not drive a screw where there is likely to be hidden

wiring behind the surface. Contact with a “live” wire will

make exposed metal parts of the tool “live” and shock

the operator. If you must drive a screw where hidden wire

may be present, always hold tool by insulated gripping

surfaces (handle) when performing the operation to

prevent a shock to the operator.

CAUTION:

The impact driver is not designed to be used as a drill.

DRIVING OR REMOVING SCREWS

See Figures 5 - 6, page 11.

 Place the direction of rotation selector in the correct

position for the operation.

 Hold the impact driver with one hand.

 Place the bit on the screw head and slowly depress the

switch trigger. Start the bit slowly for more control.

 As the screw is driven, impacting will begin.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Pas de commentaire

Ryobi P234G Manuel de l'opérateur Page 9