Ryobi BT3000 Spécifications Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 42
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
Page 14
Figure 12: Rip Fence Installation
Figure 11: Miter Fence Installation
ASSEMBLY
MITER
TABLE BASE
HOLE "A"
LOCATOR
PIN
ADJUSTING
CLAMP
MITER
FENCE HOLDER
MITER FENCE
MITER
INDICATOR
HOLE "B"
REAR RAIL
Figure 10: Miter Table Base Installation
TABLE
SLOT
SCREW
FRONT
BLOCK
MOUNTING
HOLE
RIP
FENCE
HEX NUT
ATTACHMENT
BOLT
SCALE
INDICATOR
FRONT
LIP
REAR
LIP
REAR
RAIL
TO INSTALL MITER TABLE AND FENCE
1. Install the sliding miter table assembly over the front and
rear rails.
See Figure 10.
Check that it slides easily on
the rails. Push both front miter locking clamps down
evenly on each side to secure. Repeat for both rear miter
locking clamps.
NOTE: DO NOT force miter locking clamps fully down.
Tighten only to flat "seated" position.
2. To install the miter fence holder to the miter fence,
loosen the attachment bolt by turning the adjusting
clamp (the knob on top) counterclockwise. Make sure
the adjusting clamp is loose enough so the bolt has
enough clearance to slide in the table slot. Slide the tabs
into the grooves in the miter fence.
See Figure 11.
3. Mount the miter fence to the miter table by installing the
locator pin (below the miter fence) into hole “A” or “B”.
(Hole "A" is closest to the blade.) At the same time, place
the attachment bolt in the slot. Secure the adjusting
clamp, but do not tighten.
NOTE: Hole “A” should be used for short pieces of wood
and hole “B” should be used for long or wide pieces of
wood.
4. Adjust the miter indicator to the scale.
5. Securely tighten the adjusting clamp.
TO INSTALL ACCESSORY TABLE
AND RIP FENCE
1. Place the accessory table on the front and back rails,
fitting the lips into the top slot of the rear rail. Position the
slot on the underside of the accessory table onto the
front rail and tighten the lever securely.
2. Remove the scale indicator assembly from the plastic
bag and install on either side of the rip fence. The pan
head screw (#8-32 x 1/2 in.) goes on the outside of the
front block. The scale indicator and hex nut (#8-32) go
immediately behind the front lip of the front block.
3. To install the rip fence, place the rear lip on the rear rail
and pull slightly toward the front of the unit. Lower front
end onto the guide surfaces on top of the front rail. Check
for a smooth gliding action. Swing the locking handle
down to automatically align and secure the fence. When
securely locked, the locking handle should point
downward.
C.BLADE AND GUARD
ASSEMBLY
WARNING:
Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and
possible serious injury.
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Commentaires sur ces manuels

Pas de commentaire