Ryobi BT3000 Spécifications Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 42
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
Page 25
OPERATION
TO MAKE A BEVEL CROSS CUT
See Figure 40.
It is recommended that you place the piece to be saved on
the left side of the blade and that you make a test cut on scrap
wood.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid serious personal injury.
1. Remove the rip fence by lifting the locking handle.
2. Move the bevel locking lever to the right for Angle mode.
Turn the blade adjustment handle until the bevel indicator
is at the desired angle. Push the bevel locking lever
securely to the left to lock the angle.
3. Set the blade to the correct depth for the workpiece.
4. Loosen the adjusting clamp on the miter fence. Set the
miter fence to 90 degrees with either the quick-stop or
the miter scale.
5. Make sure the miter fence will not contact the blade as
the wood feeds into the blade. Make a trial pass of the
miter table. The end of the miter fence should not contact
the blade. Loosen the adjusting clamp to move it away
from the blade if needed.
6. Place a support (the same height as saw table) behind
the saw for the cut work.
7. Make sure the wood is clear of the blade before turning
on the saw.
8. Let the blade build up to full speed before moving the
miter table to feed the workpiece into the blade.
9. Hold the work with both hands and push the miter table
to feed the work into the blade.
QUICK
STOP
MITER
FENCE ADJUSTING
CLAMP
Figure 40: Making a Bevel Cross Cut
NOTE:The wooden insert should be attached with wood
screws from the bottom, through the two holes provided
in the casting. Securely trap the wooden insert between
the accessory table and the saw table.
4. Place sliding miter table on the right side of blade and lock
securely.
BEVEL LOCKING LEVER
MITER TABLE
Figure 41: Making a Bevel Rip Cut
TO MAKE A BEVEL RIP CUT
See Figure 41.
WARNING:
The rip fence must be on the left side of the blade to avoid
trapping the wood and causing kickback.
WARNING:
Make sure the blade guard assembly is installed and
working properly to avoid serious personal injury.
It is recommended you make test cuts on scrap wood.
Before making this cut, use scrap wood to make an insert 5
in. wide, 22 in. long, and 3/4 in. thick. You may want to make
others that are more than 5 in. wide.
1. Remove miter fence, sliding miter table, and accessory
table.
2. Replace accessory table on the left side of blade. DO
NOT Lock.
3. Place the wooden insert between the accessory table
and the saw table to support the workpiece.
See Figure
41
. Secure the wooden insert with screws as noted.
Adjust the accessory table firmly against the wooden
insert and lock securely.
WOODEN
INSERT
RIP
FENCE
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Commentaires sur ces manuels

Pas de commentaire