Page 30
MAINTENANCE
TO ALIGN THE MITER LOCKING CLAMPS
See Figure 47.
WARNING:
Unplug the saw to prevent accidental starting.
The miter locking clamps are preset at the factory but may
require adjusting after extended use or if damage occurs in
shipping. Adjust them with the following steps:
1. Loosen the set screw behind each locking clamp.
2. Loosen the screw on top of each locking clamp.
3. Lift the locking clamp to the Up position.
4. Push the clamp forward tight against the front rail to bring
the clamp into alignment.
5. When the clamps are correctly positioned, retighten the
screws and the set screws.
6. Push both front and rear miter locking clamps down to
secure the sliding miter table.
TO ADJUST THE FRONT AND REAR RAIL
CLAMPS
See Figure 48.
The rail clamps are located below the rails and ensure tight
attachment of the rail. Following extended use, the rail holder
nut inside the rails may need adjusting.
1. Remove the miter table and accessory table.
2. Remove the front and rear rails by loosening the rail
clamps and sliding the rails off.
3. Rotate each rail clamp to the left until it hits or comes in
contact with the bottom of the saw table.
4. Tighten rail holder nut until it is snug.
5. Loosen rail holder nut one-fourth (1/4) turn.
6. Replace the rails and check the rail clamps.
TO ADJUST THE ACCESSORY TABLE
See Figure 49.
After extended use, the accessory table may work loose
causing the accessory table to be loose on the rails. Follow
the steps below, when adjustments are required:
1. Remove the hex nut on the lever using a 3/8 in. nut driver.
2. Remove the back-up plate and spring plate. Rotate the
spring plate 180° and re-install on the handle shaft.
3. Reassemble all parts and tighten hex nut securely.
NOTE: The spring plate offers two ends for use before
requiring replacement.
SCREW
FRONT RAIL
WASHER
RAIL
CLAMP
RAIL
HOLDER NUT
HEX
MOUNTING BOLT
Figure 48: Adjusting the Rail Clamps
RETAINING
RING
ACCESSORY TABLE
CAP SCREW
LEVER
BACK-UP
PLATE
HANDLE
SHAFT
Figure 49: Adjusting the Accessory Table
HEX NUT
SPRING PLATE
WASHER
MITER
LOCKING CLAMP
Figure 47: Adjusting the Miter Locking Clamps
SET
SCREW
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels