Ryobi BT3000 Spécifications télécharger pdf (Page 37)

Page 37

TROUBLESHOOTING

PROBLEM CAUSE SOLUTION

Saw does not make accurate 90 or

45 degree cuts. Positive stops inside cabinet need

adjusting (Bevel Cuts). Adjust positive stops.

Miter gage is misaligned

(Miter Cuts). Adjust the miter gage.

Blade adjusting handle is hard to

turn. Gears or Screw Post inside cabinet

are clogged with sawdust. Clean the gears or screw post.

Saw does not start. Motor cord or wall cord is not

plugged in. Plug in motor cord or wall cord.

Circuit fuse is blown. Replace circuit fuse.

Circuit breaker is tripped. Reset circuit breaker.

Cord or switch is damaged. Have the cord or switch replaced at

a RYOBI AUTHORIZED SERVICE

CENTER.

Blade makes poor cuts Blade is dull or dirty. Clean, sharpen or replace blade.

Blade is wrong type for cut being

made. Replace with correct type.

Blade is mounted backwards. Remount blade.

Blade does not lower when turning

blade adjusting handle. Back side of riving knife has come

in contact with saw table. Realign and adjust the riving knife.

Locking lever is not at full left

position. Move locking lever to left.

Motor labors in rip cut. Blade not proper for rip cut. Change blade; rip blade typically

has fewer teeth such as Ryobi

4650324, 24 tooth, carbide rip

blade.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

Ryobi BT3000 Spécifications Page 37