Ryobi OJ1802 Manuel de l'opérateur télécharger pdf (Page 10)

ADJUSTMENTS

WARNING:

The orbital jig saw should never be connected to a

power supply when you are assembling parts, making

adjustments, cleaning, performing maintenance, or

when the tool is not in use. Disconnecting the tool will

prevent accidental starting that could cause serious

injury.

BLADE STORAGE

See Figure 2.

Convenient feature on your saw is blade storage

compartment. As shown in figure 2, the blade storage

compartment is located on the back of your saw. This is

convenient for storing extra blades and storing blades

when not in use.

 To open: Push the door down with your thumb or

finger. Place blades in blade storage compartment.

 To close: Push the door up with your thumb or

finger.

TO INSTALL BLADES

See Figure 3.

Follow these steps to install saw blades.

 Remove battery pack. See Figure 13.

WARNING:

Failure to remove battery pack from saw could result in

accidental starting causing possible serious personal

injury.

 Lift blade clamp lock / release lever located on front

of saw.

 Insert saw blade between blade clamp and saw bar.

 Lock blade clamp lever.

 Replace battery pack.

Fig. 2

Fig. 3

BLADE

STORAGE

COMPARTMENT

SAW BLADE

BLADE CLAMP

BLADE CLAMP LOCK

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Ryobi OJ1802 Manuel de l'opérateur Page 10