Ryobi OJ1802 Manuel de l'opérateur télécharger pdf (Page 13)

OPERATION

GENERAL CUTTING

See Figure 4.

Rest the front of the saw base on the workpiece and align

cutting edge of the blade with the line on your workpiece.

Start your saw and move it forward on the work surface.

Apply downward pressure to keep the saw steady and only

enough forward pressure to keep the blade cutting.

DO NOT FORCE YOUR SAW

Forcing your saw may overheat the motor and break saw

blades. Broken saw blades must be discarded. Remove

the broken portion of the saw blade from the clamp and

install a new saw blade.

ORBITAL MOTION

See Figure 4.

The blade of your saw cuts in orbital motion. This feature

is adjustable and provides faster more efficient cutting.

With orbital motion the blade cuts through your work in the

upstroke but does not drag across your work in the

downstroke. The higher settings should be used when fast

cutting in soft material is desired. The lower settings

should be used when cutting materials with more resis-

tance.

STRAIGHT CUT

See Figure 4.

A straight cut can be made by clamping a piece of wood or

straightedge to the workpiece and guiding the edge of your

saw against it. Make the cut from one direction only: don't

cut halfway and complete the cut from the opposite end.

SCROLL CUTTING

See Figure 5.

Scroll cuts can be made with your jig saw by guiding the

direction of the cut with applied pressure on the handle as

shown in figure 5.

WARNING:

Excessive side pressure to the blade could result in

broken blades or damage to the material being cut.

Fig. 4

Fig. 5

TO INCREASE

ORBITAL

SETTING

TO DECREASE

ORBITAL

SETTING

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi OJ1802 Manuel de l'opérateur Page 13

Commentaires sur ces manuels