Ryobi AP13AK Spécifications

Naviguer en ligne ou télécharger Spécifications pour Planeurs de puissance Ryobi AP13AK. Ryobi AP13AK Product specifications Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 14
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
N197
AP13AK
PLANER THICKNESSER WITH ANTI KICKBACK
OWNER’S OPERATION MANUAL
Vue de la page 0
1 2 3 4 5 6 ... 13 14

Résumé du contenu

Page 1 - OWNER’S OPERATION MANUAL

N197AP13AKPLANER THICKNESSER WITH ANTI KICKBACKOWNER’S OPERATION MANUAL

Page 2

ADJUSTMENTPage 9NOTE: Remove gauge block before starting machine.Thickness planing is the sizing of the material to a desired thickness, whil

Page 3 - RULES FOR SAFE OPERATION

MAINTENANCELUBRICATION The recommended lubrication for roller chains used in medium to low operation is to simply wipe the chain clean. When ther

Page 4

TROUBLESHOOTING PROBLEM POSSIBLE CAUSE REMEDYFUZZY GRAIN 1. Planing wood with high moisture content.2. Dull Blades.1. Dry the wood2. Sharpen Blades.TO

Page 5

NOTEPage 12

Page 6

RYOBI TECHNOLOGIES AUSTRALIA PTY. LTD.GUARANTEERYOBI TECHNOLOGIES AUSTRALIA PTY. LTD.A.B.N. 98 002 277 509 SYDNEY: 359-361 Horsley Road, Milperra, N.

Page 7

Page 1Table of ContentsSpecicatonsRules for Safe OperationLoose Parts ListOperationAdjustmentMaintenanceTroubleshooting 112-4456-91011PRODUCT SPECI

Page 8

RULES FOR SAFE OPERATIONThe purpose of safety rules is to attract your attention topossible dangers. The safety symbols and the explanations

Page 9

RULES FOR SAFE OPERATIONPage 3PowerSwitchTable ExtentionDepth ScaleHand CrankStock RollersOverload SwitchAlways wear eye protection when operatin

Page 10 - WARNING:

Page 4LOOSE PARTS LIST1) “C” Circlip ...

Page 11

MOVING THE PLANER (Fig. 1) The planer can be carried using the handles on either side of the frame. Make sure the table extensions are closed before m

Page 12 - 2. Dull Blades

Page 6ADJUSTMENTADJUST DEPTH OF CUT (Fig. 5)To adjust the depth of cut, turn the cutterhead-raising hand crank in the direction marked on top

Page 13

SETTING THE BLADE HEIGHT (Fig. 8&8a)To obtain a blade projection of 1.5mm, place the blade setting gauge (E) on the cutterhead with both g

Page 14 - GUARANTEE

ADJUSTMENTPage 8MAKING THE CUTTERHEAD AND WORKTABLE PARALLEL (Fig. 9~12)Plane a workpiece and measure thickness after the cut. If the thickness is not

Commentaires sur ces manuels

Pas de commentaire