Ryobi P610 Manuel de l'opérateur télécharger pdf (Page 15)

OPERATION

PLANING EDGES

See Figure 12.

Follow the directions in Operating the Planer. Hold the edge

guide firmly against the edge of the work surface.

ATTACHING THE EDGE GUIDE FOR MAKING

RABBET CUTS

 Lock the switch by placing the lock-off button in the center

position.

 Remove the battery pack from the tool.

 Attach the bracket to the left side of the planer using the

knob bolt.

 Attach the edge guide loosely to the bracket using the

knob nut and the carriage head bolt.

 Adjust the edge guide to the desired width for the rabbet

cut.

 Tighten the retaining knob securely.

MAKING RABBET CUTS

See Figure 13.

Follow the directions in the Operating the Planer section

earlier in this manual. Hold the edge guide firmly against the

edge of the work surface.

The depth of the rabbet is determined by the depth of the

cut and the number of passes made along the work surface.

The maximum depth of the rabbet cut is 1/2 in. Cuts should

be made in passes of 1/64 in. or less to reach the desired

depth. The width of the rabbet cut may be adjusted by

moving the edge guide.

EDGE GUIDE

WORKPIECE

EDGE GUIDE

Fig. 12

Fig. 13

WORKPIECE

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Ryobi P610 Manuel de l'opérateur Page 15