Ryobi RB101 Manuel de l'opérateur

SAVE THIS MANUAL FOR FUTURE REFERENCEYour buffer/polisher has been engineered and manufactured to our high standard for dependability, ease of operati

10WARNING: Before connecting the buffer/polisher to the power source, always check to make sure the switch is not in ON position. Failure to do

11OPERATIONFig. 6Fig. 4Fig. 5APPLICATION OF LIQUID POLISHSee Figure 4.Apply a small circle of liquid (about the size of a half- dollar) ar

12WARNING:When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.WAR

13TROUBLESHOOTING Problem Possible Cause SolutionWax does not go on evenlyToo much wax on the bonnetRemove a portion of the wax and retry.Pol

14ONE WORLD TECHNOLOGIES, INC.1428 Pearman Dairy Road, Anderson, SC 29625Phone 1-800-525-2579www.ryobitools.com• SERVICENow that you have purchased y

2 Introduction ...

3GENERAL SAFETY RULESWARNING: Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fir

4SERVICE Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel may resu

5SYMBOLSSome of the following symbols may be used on this tool. Please study them and learn their meaning. Proper interpretation of these symbols will

6The following signal words and meanings are intended to explain the levels of risk associated with this product.DANGER:Indicates an imminently hazard

7EXTENSION CORDSWhen using a power tool at a considerable distance from a power source, be sure to use an extension cord that has the capacity to h

8FEATURESFig. 1PRODUCT SPECIFICATIONSOrbit Diameter ..... 1/2 in.Motion ...

9WARNING: If any parts are damaged or missing do not operate this tool until the parts are replaced. Failure to heed this warning could res