Ryobi RS290G Manuel d'utilisation et d'entretien télécharger pdf (Page 4)

4 - English

SANDER SAFETY WARNINGS

Hold power tool by insulated gripping surfaces, when

performing an operation where the cutting accessory

may contact hidden wiring. Cutting accessory contact-

ing a “live” wire may make exposed metal parts of the

power tool “live” and could give the operator an electric

shock.

Know your power tool. Read operator’s manual care-

fully. Learn its applications and limitations, as well

as the specific potential hazards related to this tool.

Following this rule will reduce the risk of electric shock,

fire, or serious injury.

Always wear eye protection with side shields marked

to comply with ANSI Z87.1. Following this rule will re-

duce the risk of serious personal injury.

Protect your lungs. Wear a face or dust mask if the

operation is dusty. Following this rule will reduce the

risk of serious personal injury.

Protect your hearing. Wear hearing protection during

extended periods of operation. Following this rule will

reduce the risk of serious personal injury.

Inspect tool cords periodically and, if damaged, have

repaired at your nearest authorized service center.

Constantly stay aware of cord location. Following this

rule will reduce the risk of electric shock or fire.

Check damaged parts. Before further use of the

tool, a guard or other part that is damaged should

be carefully checked to determine that it will operate

properly and perform its intended function. Check for

alignment of moving parts, binding of moving parts,

breakage of parts, mounting, and any other conditions

that may affect its operation. A guard or other part that

is damaged should be properly repaired or replaced

by an authorized service center. Following this rule will

reduce the risk of shock, fire, or serious injury.

Make sure your extension cord is in good condition.

When using an extension cord, be sure to use one

heavy enough to carry the current your product will

draw. A wire gauge size (A.W.G.) of at least 16 is

recommended for an extension cord 50 feet or less

in length. A cord exceeding 100 feet is not recom-

mended. If in doubt, use the next heavier gauge. The

smaller the gauge number, the heavier the cord. An

undersized cord will cause a drop in line voltage resulting

in loss of power and overheating.

Inspect for and remove all nails from lumber before

using this tool. Following this rule will reduce the risk of

serious personal injury.

If the power supply cord is damaged, it must be re-

placed only by the manufacturer or by an authorized

service center to avoid risk.

Save these instructions. Refer to them frequently and

use them to instruct others who may use this product. If

you loan someone this product, loan them these instruc-

tions also.

WARNING:

This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may

contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive

harm. Wash hands after handling.

Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products and,

• arsenic and chromium from chemically treated lumber.

Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your

exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially

designed to filter out microscopic particles.

CALIFORNIA PROPOSITION 65

1 2 3 4 5 6 7 8 9 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi RS290G Manuel d'utilisation et d'entretien Page 4

Commentaires sur ces manuels