Ryobi RS290G Manuel d'utilisation et d'entretien télécharger pdf (Page 7)

7 - English

FEATURES

PRODUCT SPECIFICATIONS

Sanding Disc Diameter ................................................ 5 in.

Motion ......................................................... Random Orbit

Orbit Diameter ........................................................ 3/32 in.

No Load Speed ..................................... 12,500/min (RPM)

Input ...............................120 V, 60 Hz, AC only, 2.6 Amps

Net Weight ...........................................................3-1/2 lbs.

ASSEMBLY

WARNING:

Do not use this product if it is not completely assembled

or if any parts appear to be missing or damaged. Use of

a product that is not properly and completely assembled

or with damaged or missing parts could result in serious

personal injury.

WARNING:

Do not attempt to modify this product or create acces-

sories or attachments not recommended for use with this

product. Any such alteration or modification is misuse

and could result in a hazardous condition leading to

possible serious personal injury.

If any parts are damaged or missing, please call 1-800-525-2579 for assistance.

OPERATION

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product. The

use of attachments or accessories not recommended

can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:

 Sanding on wood surfaces

 Removing rust from and sanding steel surfaces

SELECTING SANDING DISCS

Selecting the correct size grit and type sanding disc is an

extremely important step in achieving a high quality sanded

finish. Aluminum oxide, silicon carbide, and other synthetic

abrasives are best for power sanding. Natural abrasives, such

as flint and garnet are too soft for use in power sanding.

In general, coarse grit will remove the most material and finer

grit will produce the best finish in all sanding operations. The

condition of the surface to be sanded will determine which

grit will do the job. If the surface is rough, start with a coarse

grit and sand until the surface is uniform. Medium grit may

then be used to remove scratches left by the coarser grit and

finer grit used for finishing of the surface. Always continue

sanding with each grit until surface is uniform.

WARNING:

If your sanding job becomes particularly dusty or if you

have a breathing condition, wear a dust mask or respirator

to prevent damage to your health.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi RS290G Manuel d'utilisation et d'entretien Page 7

Commentaires sur ces manuels