Ryobi CR120L Manuel d'utilisateur télécharger pdf (Page 8)

8 – English

OPERATION

WARNING:

Excessive side pressure to the blade could result in

broken blades or damage to the material being cut.

METAL CUTTING

See Figure 7, page 10.

Metals such as sheet steel, pipe, steel rods, aluminum, brass,

and copper may be cut with the hybrid saw. Be careful not to

twist or bend the saw blade. Do not force. We recommend

cutting oil when cutting most soft metals and steel. Cutting

oil will also keep blades cool, increase cutting action, and

prolong blade life.

Never use gasoline since normal sparking of motor could

ignite fumes. Clamp the work firmly and cut close to the

clamping point to eliminate any vibration of the work being

cut. When cutting conduit pipe or angle iron, clamp work

in a vise if possible and cut close to the vise. To cut thin

sheet material, sandwich the material between hardboard

or plywood and clamp the layers to eliminate vibration and

material tearing.

WARNING:

Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals

known to cause cancer, birth defects or other reproductive harm. Some examples of thesechemicals are:

•leadfromlead-basedpaints,

•crystallinesilicafrombricksandcementandothermasonryproducts,and

•arsenicandchromiumfromchemically-treatedlumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to

these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks

that are specially designed to filter out microscopic particles.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Pas de commentaire

Ryobi CR120L Manuel d'utilisateur Page 8