Ryobi CSB125 Manuel d'utilisateur télécharger pdf (Page 10)

10 - English

To guard against kickback, avoid dangerous practices such

as the following:

Setting blade depth incorrectly

Sawing into knots or nails in workpiece

Twisting the blade while making a cut

Making a cut with a dull, gummed up, or improperly set

blade

Supporting the workpiece incorrectly

Forcing a cut

Cutting warped or wet lumber

Operating the tool incorrectly or misusing the tool

To lessen the chance of kickback, follow these safety

practices:

Keep the blade at the correct depth setting. Less than a

full tooth of the blade teeth should be visible below the

workpiece.

Inspect the workpiece for knots or nails before cutting.

Never saw into a knot or nail.

Make straight cuts. Always use a straight edge guide

when rip cutting. This helps prevent twisting the blade.

Use clean, sharp, and properly set blades. Never make

cuts with dull blades.

Support and clamp the workpiece properly before

beginning a cut.

Use steady, even pressure when making a cut. Never

force a cut.

Do not cut warped or wet lumber.

Hold the saw firmly with both hands and keep your body

in a balanced position so as to resist the forces if kickback

should occur.

WARNING:

When using the saw, always stay alert and exercise

control. Do not remove the saw from the workpiece while

the blade is moving.

OPERATION

SAW BLADES

The best of saw blades will not cut efficiently if they are not

kept clean, sharp, and properly set. Using a dull blade will

place a heavy load on the saw and increase the danger of

kickback. Keep extra blades on hand, so that sharp blades

are always available.

Gum and wood pitch hardened on blades will slow the

saw down. Remove saw blade from the saw and use gum

and pitch remover, hot water, or kerosene to remove these

accumulations. DO NOT USE GASOLINE.

BLADE GUARD SYSTEM

See Figure 8, page 17.

The lower blade guard attached to the circular saw is there

for your protection and safety. Do not alter it for any reason.

If it becomes damaged, do not operate the saw until you

have the guard repaired or replaced. Always leave guard in

operating position when using the saw.

DANGER:

When sawing through work, lower blade guard does not

cover blade on the underside of work. Since blade is

exposed on underside of work, keep hands and fingers

away from cutting area. Any part of your body coming

in contact with moving blade will result in serious injury.

CAUTION:

Never use saw when guard is not operating correctly.

Check the guard for correct operation before each use.

The guard is operating correctly when it moves freely and

readily returns to the closed position. If you drop the saw,

check the lower blade guard and bumper for damage at

all depth settings before reuse.

WARNING:

Never tie the lower blade guard in a raised position.

Leaving the blade exposed could lead to serious injury.

If at any time the lower blade guard does not snap closed,

unplug the saw from the power supply. Exercise the lower

guard by moving it rapidly back and forth from the full open

position to the closed position several times. Normally this

will restore the guard to its normal operating condition. If

it does not correct a slow or sluggish closing lower guard,

do not use the saw. Take it to an authorized factory service

center for repair.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB125 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi CSB125