Ryobi CSB125 Manuel d'utilisateur télécharger pdf (Page 11)

11 - English

OPERATION

STARTING/STOPPING THE SAW

See Figure 9, page 17.

To start the saw: Depress the switch.

Always let the blade reach full speed, then guide the saw

into the workpiece.

WARNING:

The blade coming in contact with the workpiece before

it reaches full speed could cause the saw to “kick back”

towards you resulting in serious injury.

To stop the saw: Release the switch.

After you release the switch, allow the blade to come to a

complete stop. Do not remove the saw from the workpiece

while the blade is moving.

ADJUSTING BLADE DEPTH

See Figure 10, page 17.

Always keep correct blade depth setting. Less than a full tooth

of the blade teeth should be visible below the workpiece.

More blade depth will increase the chance of kickback and

cause the cut to be rough. For more depth of cut accuracy,

a scale is located on the upper blade guard.

To adjust the blade depth:

Unplug the saw.

Pull depth lock lever upward to release. The depth lock

lever is located between the guard and handle of the saw.

Determine the desired depth of cut.

Locate depth of cut scale on back of upper blade guard.

Hold base flat against the workpiece and raise or lower

saw until the index point (or reference mark) on bracket

aligns with notch on blade guard.

Push down on the depth lock lever to lock the lever in

place and secure the position.

OPERATING THE SAW

See Figures 11 - 13, pages 17 - 18.

It is important to understand the correct method for operating

the saw. Refer to the figures in this section to learn the correct

and incorrect ways for handling the saw.

WARNING:

To make sawing easier and safer, always maintain proper

control of the saw, by holding the saw with both hands.

Loss of control could cause an accident resulting in

possible serious injury.

DANGER:

When lifting the saw from the workpiece, the blade is

exposed on the underside of the saw until the lower blade

guard closes. Make sure the lower blade guard is closed

before setting the saw down.

WARNING:

Use clamps or other practical way to secure and

support the workpiece to a stable platform. Holding

the work by hand or against your body is unstable and

may lead to loss of control which could cause possible

serious injury.

To make the best possible cut:

Hold the saw firmly with both hands.

Avoid placing your hand on the workpiece while making

a cut.

Support the workpiece so that the cut (kerf) is always to

your side.

Support the workpiece near the cut.

Clamp the workpiece securely so that the workpiece will

not move during the cut.

Always place the saw on the workpiece that is supported,

not the “cut off” piece.

Place the workpiece with the “good” side down.

Draw a guideline along the desired line of cut before

beginning your cut.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB125 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi CSB125