Ryobi CSB125 Manuel d'utilisateur télécharger pdf (Page 14)

14 - English

WARNING:

Before performing any adjustment, make sure the tool is

unplugged from the power supply and the switch is in the

OFF position. Failure to heed this warning could result in

serious personal injury.

WARNING:

Never tie the lower blade guard in a raised position.

Leaving the blade exposed could lead to serious injury.

0° BEVEL STOP

See Figure 23, page 19.

The saw has a 0° bevel stop that has been factory adjusted

to assure 0° angle of the saw blade when making 90° cuts.

To check 0° bevel stop:

Unplug the saw.

Place the saw in an upside down position on a workbench.

Check the squareness of the saw blade plate to the base

of the saw using a combination square.

To adjust 0° bevel stop:

Unplug the saw.

Loosen bevel lock knob.

Loosen hex nut securing adjusting screw.

Turn adjusting screw and adjust base until square with

saw blade.

Tighten hex nut and bevel lock knob securely.

ADJUSTMENTS

WARNING:

Attempting a bevel cut without having the bevel lock knob

securely tightened can result in serious injury.

ADJUSTING THE DEPTH LOCK LEVER

See Figure 24, page 19.

Over time, due to wear, the depth lock lever may move from

its original setting. If the lever prematurely contacts any part

of the saw during tightening and loosening, adjust the lever

by following these steps:

Unplug the saw.

Pull depth lock lever upward to release.

Pull saw base down to the minimum depth of cut position,

then push the depth lock lever down to secure.

Insert a flathead screwdriver into the space between the

lock nut and the E-ring. Remove the E-ring.

Note the position of the lever on the nut. Slide the depth

lock lever off the lock nut.

The lock nut has six flat sides. Rotate the depth lock lever

one “flat” counter clockwise around the nut. Then slide it

back into place.

Push the E-ring back into the groove on the lock nut until

it snaps into place. Take care that the E-ring does not pop

off the lock nut.

Loosen the depth lock lever and return the base to the

full depth of cut position and lock the depth setting by

pushing downward on the depth lock lever. The base

should be locked securely in position when locked and

be free to move when released.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB125 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi CSB125