Ryobi CSB125 Manuel d'utilisateur télécharger pdf (Page 9)

9 - English

REMOVING BLADE

See Figures 1 - 3, pages 16 - 17.

Unplug the saw.

Depress and hold spindle lock button.

Remove blade screw by turning it counterclockwise with

the blade wrench, while keeping the spindle lock button

depressed.

Remove spring washer and outer blade washer (“D”

washer).

Lift lower blade guard.

Remove blade.

WARNING:

If inner flange bushing has been removed, replace it

before placing blade on spindle. Failure to do so will

prevent blade from tightening properly and could result

in serious personal injury.

 Fit the saw blade inside the lower blade guard and onto

the spindle.

 Replace “D” washer.

 Replace spring washer with cupped side against “D”

washer.

 Depress spindle lock button and replace blade screw.

 Tighten blade screw securely by turning it clockwise with

the blade wrench.

NOTE: Never use a blade that is too thick to allow the

“D” washer to engage with the flat on the spindle.

ASSEMBLY

OPERATION

DANGER:

Keep hands away from cutting area and the blade.

Keep your second hand on auxiliary handle. If both

hands are holding the saw, they cannot be cut by the

blade.

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second

is sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

APPLICATIONS

You may use this product for the purposes listed below:

Cutting all types of wood products (lumber, plywood,

paneling, composition board, and hard board)

Cross cutting/rip cutting wood products

Bevel cutting wood products

Pocket cutting wood products

WARNING:

Never use abrasive cut-off wheels of any kind with

this saw. Use of non wood cutting blades can result in

property damage or serious personal injury.

KICKBACK

See Figures 4 - 7, page 17.

Kickback occurs when the blade stalls rapidly and the saw

is driven back towards you. Blade stalling is caused by any

action which pinches the blade in the wood.

DANGER:

Release switch immediately if blade binds or saw stalls.

Kickback could cause you to lose control of the saw. Loss

of control can lead to serious injury.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB125 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi CSB125