Ryobi TSS100L1 Manuel d'utilisateur télécharger pdf (Page 21)

100

21 — English

OPERATION

WARNING:

Do not allow familiarity with tools to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes, resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this tool. The use

of attachments or accessories not recommended can

result in serious personal injury.

APPLICATIONS

This product has been designed only for the purposes listed

below:

 Cross cutting wood and plastic (do not cut metals,

ceramics or masonry products.)

 Cross cutting miters, joints, etc., for picture frames, mold-

ings, door casings, and fine joinery

 Bevel and compound cutting

 Cross cutting wide workpieces

NOTE: The blade provided is fine for most wood cutting

operations, but for fine joinery cuts or cutting plastic, use

one of the accessory blades available from the Ryobi dealer.

WARNING:

Before starting any cutting operation, clamp or bolt the

compound miter saw to a workbench. Never operate the

miter saw on the floor or in a crouched position. Failure

to heed this warning can result in serious personal injury.

WARNING:

To avoid serious personal injury, always tighten the mi-

ter lock handle securely before making a cut. Failure to

do so could result in movement of the miter table while

making a cut.

WARNING:

To avoid serious personal injury, keep hands outside

the no hands zone, at least 3 in. from the blade. Never

perform any cutting operation freehand (without holding

workpiece against the fence). The blade could grab the

workpiece if it slips or twists.

CAUTION:

Do not start the compound miter saw without checking

for interference between the blade and the miter fence.

Damage could result to the blade if it strikes the miter

fence during operation of the saw.

CUTTING WITH THE SLIDING COMPOUND

MITER SAW

WARNING:

When using a work clamp or C-clamp to secure your

workpiece, clamp workpiece on one side of the blade

only. The workpiece must remain free on one side of the

blade to prevent the blade from binding in workpiece. The

workpiece binding the blade will cause motor stalling and

kickback. This situation could cause an accident resulting

in possible serious personal injury.

WARNING:

NEVER move the workpiece or make adjustment to any

cutting angle while the saw is running and the blade is

rotating. Any slip can result in contact with the blade

causing serious personal injury.

WARNING:

Do not try to cut narrow pieces using the sliding feature.

Failure to heed this warning could result in serious per-

sonal injury.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS100L1 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TSS100L1