Ryobi TSS100L1 Manuel d'utilisateur télécharger pdf (Page 26)

100

26 — English

OPERATION

WARNING:

Never make a cut by pulling the saw toward you as

the blade can climb on top of the workpiece and come

toward you. Failure to heed this warning could result in

serious personal injury.

TO SLIDE CUT

See Figures 33 - 34.

The sliding feature will cut workpieces 12 in. wide by

3-1/2 in. thick. With the saw off, pull the saw arm forward.

Turn the saw on (let blade reach maximum speed), push the

blade down cutting into the workpiece then back toward the

rear of the saw to make a cut. Cuts are made by pushing

the saw blade away from you and toward the bevel scale

at the back of the saw stopping when the full rear position

has been reached after each cut. When the saw is running

(turned on), NEVER pull the saw blade toward you or toward

the front of the saw.

 Raise saw arm to its full height.

 Place the workpiece flat on the miter table with one edge

securely against the fence. If the board is warped, place

the convex side against the fence. If the concave edge

of a board is placed against the fence, the board could

collapse on the blade at the end of the cut, jamming the

blade. See Figures 38 - 39.

 When cutting long pieces of lumber or molding, support

the opposite end of the stock with a roller stand or with

a work surface level with the saw table. See Figure 32.

 Align the cutting line on the workpiece with the edge of

saw blade.

 Loosen the slide lock knob by turning the knob counter-

clockwise.

 Grasp the stock firmly with one hand and secure it against

the fence. Use the work clamp or a C-clamp to secure

the workpiece when possible.

 Before turning on the saw, perform a dry run of the cut-

ting operation to make sure that no problems will occur

when the cut is made.

 With the saw off, grasp the saw handle firmly then pull

the saw forward until the blade arbor (center of the saw

blade) is over the front of the workpiece.

 Squeeze the switch trigger. Allow several seconds for the

blade to reach maximum speed.

 Slowly lower the blade into and through the front edge

of the workpiece.

 Push the saw handle away from you and toward the bevel

scale at the back of the saw.

SLIDE CUT

SLIDE SAW ARM

FORWARD THEN

PUSH DOWN

PUSH

BACK

 Release the switch trigger and allow the saw blade to

stop rotating before raising the blade out of workpiece

and removing the workpiece from miter table.

NOTE: A cross cut is made by cutting across the grain of

the workpiece. A straight cross cut is made with the miter

table set at the 0° position. Miter cross cuts are made with

the miter table set at some angle other than 0°.

Fig. 33

Fig. 34

SLIDE LOCK

KNOB

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS100L1 Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TSS100L1