Ryobi TSS100L1 Manuel d'utilisateur télécharger pdf (Page 31)

100

31 — English

ADJUSTMENTS

WARNING:

Before performing any adjustment, make sure the tool is

unplugged from the power supply. Failure to heed this

warning could result in serious personal injury.

The compound miter saw has been adjusted at the

factory for making accurate cuts. However, some of

the components might have been jarred out of alignment

during shipping. Also, over a period of time, readjustment

will probably become necessary due to wear. After unpacking

the saw, check the following adjustments before you begin

using saw. Make any readjustments that are necessary and

periodically check the parts alignment to make sure that the

saw is cutting accurately.

TO ADJUST THE BEVEL PIVOT

See Figure 40.

The saw should smoothly pivot when the bevel lock lever is

“unlocked” and the saw is beveled. A “grating” sound

indicates that the bevel needs to be loosened slightly. If the

movement is tight, too loose, or there is play in the pivot, an

adjustment is required.

 Unplug the saw.

 Turn the hex nut with the blade wrench.

 Once all adjustments have been made, lift the bevel

lock lever to relock the bevel. Recheck and readjust as

needed.

Fig. 41

LASER

ON/OFF

HEX NUT

Fig. 40

LASER

SCREW A

SCREW B

TO ADJUST THE LASER GUIDE

See Figure 41.

NOTE: Avoid direct eye exposure when using the laser guide.

 Use the work clamp or a C-clamp to secure a piece of

scrap wood.

 Plug the saw into the power source and make a slight

cut to score the wood.

 Release the switch trigger and allow the saw blade to

stop rotating before raising the blade.

 Raise the saw arm.

 Lock the switch by installing a padlock (not included)

through the hole in the switch trigger.

 To adjust the laser, loosen screw A using a hex key.

NOTE: When properly aligned, the laser should be on the

left edge of the kerf. Loosen and adjust screw B only if

adjustment of screw A fails to properly align the laser.

 Once aligned, tighten the screws then remove and store

the hex key.

LASER

MARK

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS100L1 Manuel d'utilisateur Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TSS100L1