Ryobi HP24 Manuel de l'opérateur télécharger pdf (Page 7)

Page 7

OPERATION

WARNING:

Always wear safety goggles or safety glasses with side

shields when operating tools. Failure to do so could result

in objects being thrown into your eyes, resulting in possible

serious injury.

CHARGING YOUR SCREWDRIVER

This tool has been shipped in a low charge condition to

prevent possible problems. Therefore, you should charge it

overnight prior to use.

Note: Batteries will not reach full charge the first time they

are charged. Allow several cycles (driving screws followed

by recharging) for them to become fully charged.

If the charger does not charge your screwdriver under

normal circumstances, return both the screwdriver and

charger to your nearest Ryobi Authorized Service Center

for electrical check.

TO CHARGE

See Figure 2.

■ Insert charger plug into input jack making sure they are

properly connected.

■ Charger can be used with normal household voltage

of 120 volts, 60 Hz, AC only.

■ Connect charger to power supply.

■ After normal usage, 3 hours or less of charging time is

required to fully recharge batteries. Note: If batteries

are completely discharged, 6 hours or longer of charging

time is required to fully recharge batteries.

■ Do not place charger in an area of extreme heat or

cold. It will work best at normal room temperature.

COLLET

The collet on your screwdriver has been designed to accept

1/4 in. hex bits.

See Figure 3.

TO INSERT BIT

See Figure 3.

Insert bit into collet as far as possible.

Note: One bit is packed with your screwdriver.

Fig. 2

Fig. 3

COLLET

BIT

CHARGER

CHARGER PLUG

INPUT

JACK

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire

Ryobi HP24 Manuel de l'opérateur Page 7

Commentaires sur ces manuels