Ryobi HP24 Manuel du propriétaire télécharger pdf (Page 8)

ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS

To avoid the possibility of the appliance plug or receptacle getting wet, position the saw to one side

of a wallmounted receptacle. This will prevent water from dripping onto the receptacle or plug. A “drip

loop," shown in picture below, should be arranged by the user to properly position the power cord rela-

tive to the power source.

The “drip loop" is that part of the cord below the level of the receptacle,

or the connector, if an extension cord is used. This method of positioning

the cord prevents the travel of water along the power cord and coming in

contact with the receptacle. If the plug or receptacle gets wet, DO NOT

unplug the cord. Disconnect the fuse or circuit breaker that supplies

power to the tool. Then unplug and examine for presence of water in the

receptacle.

Use only extension cords that are intended for outdoor use. These

extension cords are identified by a marking “Acceptable for use with

outdoor appliances; store indoors while not in use." Use only extension

cords having an electrical rating not less than the rating of the product.

Do not use damaged extension cords. Examine extension cords before using and replace if damaged.

Do not abuse extension cords and do not yank on any cord to disconnect. Keep cords away from heat

and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the

product form the extension cord.

To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug

with wet hands.

Use of undersized extension cords result in low voltage to the motor that can result in motor burnout

and premature failure. Barranca Diamond warns that equipment returned to us showing signs of being

run in a low voltage condition, through the use of undersized extension cords, will be repaired or

replaced totally at the customer's expense. There will be no warranty claim.

To choose the proper extension cord:

• Locate the length of extension cord needed in the table below.

• Once the proper length is found, move down the column to obtain the correct AWG size required for

that length of extension cord.

HP18 & HP24 SAFETY

EXTENSION CORD LENGTH

Nameplate

Amperes

115V 25' 50' 75' 100' 150' 200'

250V 50' 100' 150' 200' 300' 400'

0 - 5 16 16 16 14 12 12

5.1 - 8 16 16 14 12 10 •

8.1 - 12 14 14 12 10 • •

12.1 - 15 12 12 10 10 • •

15.1 - 20 10 10 10 • • •

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Pas de commentaire

Ryobi HP24 Manuel du propriétaire Page 8