Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 15)

ASSEMBLY

TO ATTACH THE LEG

See Figure 7.

NOTE: The leg with the leveling foot should be installed on

the front of the saw, right side.

 Stand the table saw on end as shown in figure 7.

 Slide the leg in the leg stand tubes aligning the holes in

both tubes.

 Remove the nut from the end of the carriage bolt then

insert a carriage bolt into the hole (from the outside toward

the inside). Finger tighten using the nut.

 Repeat for remaining legs.

NOTE: Once the leg stand is in an upright position (see page

16) and the saw is level, securely tighten the nuts. Place the

saw on level ground and verify the saw’s stability before use.

TO SECURE/LEVEL THE SAW

With the leg stand open and the table saw resting on a flat,

level surface, the saw should not move or rock from side

to side. If the saw rocks from side to side, the leveling foot

needs adjusting until the leg stand is balanced.

 Turning clockwise will lower the foot.

 Turning counterclockwise will raise the foot.

TO INSTALL THE HANDLE

See Figure 8.

 Remove the screw from the handle by holding the

nut securely and turn the screw counter- clockwise to

remove the nut completely.

NOTE: Do not remove the screw from the handle or the

washer from the end of the screw.

 Place the nut into the recessed hole on the back of the

height/bevel adjusting handwheel and hold in place.

 Slide the handle, screw, and washer into the hole on the

height/bevel adjusting handwheel.

 Using a flathead screwdriver, turn the screw clockwise

and tighten in place.

Fig. 8

Fig. 6

Fig. 7

NUT

FLAT

WASHER

SLEEVE

BOLT

WHEEL

FLAT

WASHER

SPACER

NUT

CARRIAGE

BOLT

LEG STAND

TUBE

NUT

HEIGHT/BEVEL

ADJUSTING

HANDWHEEL

SCREW

HANDLE

WASHER

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31