Ryobi RTS31 Manuel de l'opérateur Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
16
ASSEMBLY
TO OPEN/CLOSE (SET-UP/TEAR DOWN) THE
LEG STAND
See Figure 9.
To open (set-up) the leg stand:
Step 1: With the saw table on end and standing to the side,
use your left hand to pull the leg stand latch towards you.
Step 2: Once the leg stand is released from the table saw
base, ease the legs of the stand down.
Steps 3 and 4: Grasp the upper leg support below the
saw cabinet. Keeping your left hand clear of the leg stand,
pull the leg stand up until it locks into place.
Step 5: With your left hand firmly on the table tilt handle,
grasp the leg stand with your right hand.
Steps 6 and 7: Push the leg stand towards the ground with
your right hand and pull in the same direction with your
left hand until the table saw is in an upright position.
To close (tear down) the leg stand:
Steps 1 and 2: Standing to the side of the table saw, grasp
the table tilt handle with your left hand. Tilt the table saw
to your left and grab the leg.
Step 3: Lower the saw to the floor until it is balanced on
end.
Step 4: Using your left hand, release the leg stand
latch.
Steps 5 and 6: Once the leg stand is released from the
table saw base, ease the legs of the leg stand toward the
floor.
Step 7: Lift the lower leg of the leg stand until it locks in
place.
Fig. 9
SET-UP TEAR DOWN
Vue de la page 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Commentaires sur ces manuels

Pas de commentaire