Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 19)

ASSEMBLY

Fig. 14

Fig. 16

SMALL BLADE

WRENCH

LARGE

BLADE WRENCH

Fig. 15

To tighten the blade:

 Using the blade wrench, place the flat open end into the

flats on the arbor shaft.

 Insert the closed end of the blade wrench over the blade

nut. Holding both wrenches firmly, push the wrench (left

side) to the back of the machine. Make sure the blade

nut is securely tightened. Do not overtighten.

 Reinstall the throat plate.

 Check all clearances for free blade rotation.

TO INSTALL THE ANTI-KICKBACK PAWLS AND

BLADE GUARD

See Figures 15 - 17.

WARNING:

Replace dull or damaged anti-kickback pawls. Dull or

damaged pawls may not stop a kickback increasing the

risk of serious personal injury.

Anti-kickback pawls should only be installed for through

cuts.

 Unplug the saw.

 Raise the saw blade by turning the height/bevel adjusting

handwheel clockwise.

 Place riving knife in “up” position.

 Reinstall the throat plate.

To install anti-kickback pawls:

 Press and hold the button on the left side of the anti-

kickback pawls.

 Align the slot in the pawls over the rear hole in the riving

knife.

 Push the pawl handle down snapping them into place

and release the button.

NOTE: Pull on the pawl handle to make sure pawls are

securely locked.

To install blade guard:

 Lift the guard lever up to unlock.

 With the front of the blade guard raised, lower the back

of the guard into the middle hole of the riving knife. Push

the front of the guard down until it is parallel to the table

(see figure 16). If the blade guard is not parallel to the

table, the riving knife is not in the “up” position.

 Lock the guard in place by pushing the guard lever down.

NOTE: Blade alignment can be adjusted for different blade

widths. Refer to: To Check and Align the Riving Knife and

Saw Blade. Check the blade guard assembly for clearances

and free movement.

PAWL

HANDLE

BUTTON

ANTI-KICKBACK

PAWLS

BLADE

GUARD

LEVER

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31