Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 20)

Fig. 18

Fig. 17

HORIZONTAL

ADJUSTMENT

VERTICAL

ADJUSTMENT

CORRECT

INCORRECT

SCREWS

TO CHECK AND ALIGN THE RIVING KNIFE AND

SAW BLADE

See Figure 18.

To check alignment of the riving knife:

 Unplug the saw.

 Raise the saw blade by turning the height/bevel adjusting

handwheel clockwise.

 Remove the anti-kickback pawls and blade guard

assembly. Place a framing square or straight edge against

both the saw blade and the riving knife.

NOTE: Place framing square between carbide teeth and

measure from blade. This step will insure framing square

is square against blade from the front to back of blade.

 The saw blade and riving knife are aligned when the

framing square contacts both the blade and riving knife

evenly with no gaps.

If the riving knife is out of alignment with the saw blade,

adjustment is needed. The riving knife must be in alignment

front to back (horizontally) and top to bottom (vertically).

To adjust (horizontally and vertically):

 Remove the anti-kickback pawls and blade guard

assembly.

 Grasp the outfeed support with both hands and pull it

until it is fully extended.

 From the back of the saw, loosen the screws holding the

mounting bracket.

 Reposition the riving knife left or right as needed to align

the riving knife with the saw blade.

 Once properly aligned, securely retighten all screws.

 Check again for squareness and continue to adjust if

needed.

ASSEMBLY

OUTFEED

SUPPORT

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31