Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 26)

OPERATION

TO CHANGE BLADE DEPTH

See Figure 28.

The blade depth should be set so that the outer points of

the blade are higher than the workpiece by approximately

1/8 in. to 1/4 in. but the lowest points (gullets) are below

the top surface.

 Raise the blade by turning the height/bevel adjusting

handwheel counterclockwise or lower it by turning the

handwheel clockwise.

TO CHANGE BLADE ANGLE (BEVEL)

See Figure 29.

 Push the bevel locking lever up for angle mode.

 To angle the blade, push the height/bevel adjusting hand-

wheel into the cabinet, to engage bevel gear, and turn

the handwheel until the bevel indicator shows the correct

angle.

 Push the bevel locking lever down to lock the angle, while

holding the height/bevel adjusting handwheel in place.

TO ADJUST THE BEVEL INDICATOR

See Figure 29.

If the bevel indicator is not at zero when the saw blade is at

90°, adjust the indicator by loosening the screws and setting

it at 0° on the bevel scale. Retighten the screws.

CHECKING SLIDING MITER TABLE AND

MAKING ADJUSTMENTS

TO POSITION THE SLIDING MITER TABLE

See Figures 30- 31.

A slide bolt is located on the front of the saw between the saw

table and the front scale. When the arrows on both the saw

table and sliding table are aligned, this bolt slides through

the holes in both tables locking them into a fixed position.

The sliding table has three positions providing additional

front support when working with larger workpieces. Always

lock the sliding table when not in use.

To unlock the sliding miter table:

 Lift the tab on the slide bolt and move the bolt to the far

right.

 Lock the bolt into position by pushing the tab down and

into the far right-hand notch.

To lock the sliding miter table:

 Lift the tab and slide the bolt through both tables.

 Lock the bolt into position by pushing the tab down and

into the notch.

NOTE: When moving the miter base, keep hands and

fingers out of areas where they may be pinched. Pull the

miter base into position with fingers extended and using

only your thumb as shown in figure 31.

Fig. 28

GULLET

Fig. 29

SLOTS FOR LOCKING

MITER TABLE

Fig. 30

MITER

SLIDE LOCK

SCREWS

ANGLED

BLADE

BEVEL

INDICATOR

HEIGHT/BEVEL

ADJUSTING HANDWHEEL

BEVEL

LOCKING

LEVER

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31