Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 27)

OPERATION

Fig. 33

Fig. 31

TO CHECK MITER BASE PARALLELISM

See Figures 32 - 33.

 Unplug the saw.

 Set saw up as if you were preparing to make a cut. Tighten

rail clamps, miter locking clamps, lock knob, etc.

 Slide miter table (A) to the front of miter base (B) as far

as it will go. Place a reference mark (C) near the end of

the miter table as shown in figure 32.

NOTE: Front of miter base is on infeed side of saw.

 Place a reference mark on one of the blade teeth (D) and

rotate the blade (E) so that the reference mark on the

blade is at the front of the throat plate.

 Place a framing square (G) against the blade and align

with reference mark on miter table. Measure the distance

between the blade and the edge of miter table.

NOTE: Place framing square between carbide teeth and

measure from blade. This step will insure framing square

is square against blade from the front to back of blade.

 Remove framing square and slide miter table to the rear

of miter base as far as it will go.

 Rotate the blade so the reference mark on the blade is

at the rear of the throat plate. Measuring from the same

mark on the blade at the rear will eliminate the effect of

blade wobble.

 Place framing square against the blade and align with

the same reference mark on the miter table. Measure the

distance between the blade and the edge of the miter

table at the rear.

 Compare whether the front and rear measurements are

the same. If they are the same, proceed with checking

the miter fence alignment. If not, this indicates the miter

base needs aligning. Miter base must then be adjusted

before checking miter fence alignment. See To Adjust

the Miter Table section that follows.

Fig. 32

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 27