Ryobi RTS31 Manuel de l'opérateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
28
TO CHECK MITER FENCE ALIGNMENT
See Figure 34.
The miter fence must be perpendicular to the blade when
set at zero degrees.
Set the miter fence (H) at 0°. Miter indicator (I) should be
set precisely on 0° and secured in place with adjusting
clamp (J).
NOTE: The quick-stop is not used when checking align-
ment. However, you may want to set it to 0° and check
and adjust it at this time. See To Adjust the Quick Stop
in the Adjustment section.
Place a framing square (G) firmly against the miter fence
(H), with the other side against the blade (E).
Check whether the miter fence and blade are square with
each other. With the framing square against the miter
fence there should be no gap from the front to the rear
of the blade.
If a gap exists, the miter fence may be out of square.
Rotate the blade and recheck. If there is a consistent gap
between the front and rear of the blade, the miter table
needs aligning. Follow the adjustment procedures that
follow.
TO ADJUST THE MITER TABLE
See Figure 35.
Remember: Check all settings before loosening screws for
the following procedures. Once screws have been loosened,
these settings must be reset.
Unplug the saw.
Set the miter fence at 0˚ then securely tighten the
lock knob.
Push the sliding miter table to the back and loosen the
right-front screw from beneath the table saw cabinet.
Loosen the nylock nut beneath the front left eccentric
screw.
Place one side of a framing square firmly against the miter
fence and the other side against the saw blade.
Using a Phillips screwdriver, turn the eccentric screw until
the miter fence and the blade are square.
Hold the eccentric screw in place with the screwdriver
and tighten the nylock nut securely.
Retighten the front right-hand screw.
Fig. 34
I
E
G
J
H
Fig. 35
OPERATION
10
15
10
40
5
4
3
2
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
6
8
0
30
30
20
40
45
10
15
10
40
5
4
3
2
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
6
8
0
30
30
20
40
45
10
15
10
40
0
30
30
20
40
45
MITER
FENCE
SLIDING
MITER
TABLE
RIGHT
FRONT
SCREW
FRAMING
SQUARE
NYLOCK
NUT
ECCENTRIC
SCREW
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Commentaires sur ces manuels

Pas de commentaire