Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 29)

OPERATION

WARNING:

To reduce the risk of injury, always make sure the rip fence

is parallel to the blade before beginning any operation.

TO SET THE RIP FENCE SCALE INDICATOR

TO THE BLADE

See Figure 36.

Begin with the blade at a zero angle (straight up).

 Unplug the saw.

 Loosen the rip fence by lifting the locking lever.

 Using a framing square, set the rip fence 2 in. from the

blade tip edge.

 Loosen the screw on the scale indicator and align with

the 2 in. mark as shown.

 Tighten the screw and check the dimension and the rip

fence.

TO USE THE RIP FENCE

See Figure 37.

 Place the rip fence flat on the saw table, push the fence

towards the front rail to align the fence to the saw table.

 Push the locking lever down to secure the fence.

Check for a smooth gliding action. If adjustments are needed,

see To Check the Alignment of the Rip Fence to the Blade

in the Adjustment section of this manual.

Fig. 37

REAR

LIP

RIP FENCE

LOCKING

LEVER

SAW

TABLE

FRONT

RAIL

LOCKING

LEVER

BLADE

RIP

FENCE

2 in.

MARK

SCALE

INDICATOR

Fig. 36

2 in.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31