Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 31)

OPERATION

HEELING (PARALLELING) THE BLADE

See Figures 40 - 41.

WARNING:

The blade must be square so the wood does not bind

resulting in kickback. Failure to do so could result in

serious personal injury.

Do not loosen any bolts for this adjustment until you have

checked with a square and made test cuts to be sure adjust-

ments are necessary. Once the bolts are loosened, these

items must be reset.

 Unplug the saw.

 Lift the blade guard. Raise the blade all the way by turning

the height/bevel adjusting handwheel.

 Mark beside one of the blade teeth at the front of the blade.

Place a framing square even with the front of the saw

table and the side of the saw blade as shown in figure 40.

 Turn the blade so the marked tooth is at the back.

 Move the framing square to the rear and again measure

the distance. If the distances are the same, the blade is

square.

If the distances are different, square the blade with the

following steps:

 Extend the extension table, see page 30.

 Loosen adjusting bolts (1), (3), (4), and (5).

NOTE: The adjusting bolts are located above the height/

bevel adjusting handwheel and under the saw table in the

front of the saw.

 Turn adjusting bolt (2) left or right until the blade is

square.

NOTE: If the back of the blade was too far from the fram-

ing square, place a block of wood on the left side of the

blade and push it into the blade until the blade is square.

Retighten the bolts.

If the back of the blade was too close to the framing

square, place a block of wood on the right side of the

blade and push it into the blade until the blade is square.

Retighten the bolts.

WARNING:

To reduce the risk of injury from kickback, align the rip

fence to the blade following any blade adjustments.

Always make sure the rip fence is parallel to the blade

before beginning any operation.

ADJUSTING

BOLTS (3)

Fig. 41

Fig. 40

(1)

(2)

(3)

FRAMING

SQUARE

FRAMING

SQUARE

ADJUSTING

BOLTS (4 AND 5)

SAW BLADE OUT OF ALIGNMENT

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31