Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 38)

ADJUSTMENTS

WARNING:

Before performing any adjustment, make sure the tool is

unplugged from the power supply and the switch is in the

OFF position. Failure to heed this warning could result in

serious personal injury.

The table saw has been adjusted at the factory for making

very accurate cuts. However, some of the components might

have been jarred out of alignment during shipping. Also,

over a period of time, readjustment will probably become

necessary due to wear.

To avoid unnecessary set-ups and adjustments, a good prac-

tice is to check your setups carefully with a framing square

and make practice cuts in scrap wood before making finish

cuts in good workpieces. Do not start any adjustments until

you have checked with a square and made test cuts to be

sure adjustments are needed.

TO REPLACE THE BLADE

See Figures 53 - 55.

Blade kerf width must be within the limits stamped on the

riving knife.

 Unplug the saw.

 Remove the blade guard and anti-kickback pawls.

 Lower the saw blade and remove the throat plate.

 Make sure the bevel locking lever is locked.

 Raise the saw blade to full height.

 Insert the open end of the blade wrench onto the flats on

the arbor shaft.

 Insert the closed end of the blade wrench over the blade

nut. Holding both wrenches firmly, pull the outside wrench

(right side) forward while pushing the inside (left side) to

the back of the saw. Remove the blade nut and blade

washer.

 Unlock the release locking lever and remove the blade.

To install a standard blade:

 Place the new blade on the arbor shaft (the teeth must

point down toward the front of the saw to work properly).

 Place the blade washer and the blade nut over the arbor

shaft. Be sure the flat side of the blade washer faces

the blade and that all items are snug against the arbor

housing. Make sure the blade nut is securely tightened.

Do not overtighten.

 Lock the release lever.

 Rotate the blade by hand to make sure it turns freely.

 Lower the saw blade and reinstall the throat plate.

NOTE: To replace the blade with an accessory blade, follow

the instructions provided with the accessory.

THROAT

PLATE

RIVING

KNIFE

BLADE

Fig. 55

Fig. 54

Fig. 53

BLADE

WRENCH

BLADE

WRENCH

BLADE

NUT

BLADE

WASHER

ARBOR

SHAFT

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31