Ryobi C2600 Manuel de l'opérateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 19
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
Page 13
0
15
ADJUSTMENTS
Fig. 11
DEPTH STOP
The depth stop limits the wheel's downward travel. It
allows the wheel to go below the machine base enough
to maintain full cutting capacities.
The adjustable depth stop is a nylok bolt threaded into the
base of the machine at the rear. To adjust the depth stop
use an 8 mm wrench to raise or lower the depth stop bolt.
The depth stop is factory set to provide maximum cutting
capacity for the 14 in. (356 mm) abrasive wheel provided
with your cut-off machine.
When the diameter of the wheel has been reduced due to
wear, it may be necessary to adjust the depth stop to provide
maximum cutting capacity. When a new abrasive wheel is
installed, it is necessary to check the clearance of the wheel
to the machine base support.
DEPTH STOP ADJUSTMENTS
See Figure 11.
Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in acci-
dental starting causing possible serious personal injury.
Loosen the depth stop bolt that is against the machine
base.
The depth stop is lowered by turning the depth stop bolt
clockwise and raised by turning the bolt counterclockwise.
By pressing down on the machine arm, lower the wheel
and check clearance and maximum cutting distance
(distance from adjustable stationary vise where wheel
enters) to front of machine base slot.
Adjust if necessary.
CAUTION:
Do not start your abrasive cut-off machine without
checking for interference between the wheel and the
machine base support. Damage may result to the wheel
if it strikes the machine base support during operation of
the machine.
Tighten the depth stop bolt with the 8 mm hex key
provided.
DEPTH STOP
BOLT
DEPTH STOP
BOLT
OPERATION
APPLICATIONS
(Use only for the purposes listed below)
Cutting all types of metals such as 2 in. x 6 in. steel
framing studs.
Cutting hard metal iron stock such as square bar stock
and angle iron.
Cutting metal tube and pipe stock.
TO RAISE
TO LOWER
WARNING:
Cutting steel will cause sparks. Do not operate in the
presence of combustible or flammable materials. Failure
to heed this warning could result in a fire or serious per-
sonal injury.
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Commentaires sur ces manuels

Pas de commentaire