Page 15
15
45
0
OPERATION
CUT-OFF
See Figures 14 and 15.
A cut-off is made by cutting across the width of the
workpiece. A straight crosscut is made with the adjustable
flip fence set at the zero degree position. Angled cut-offs
are made with the adjustable flip fence set at some angle
other than zero.
To cut with your cut-off machine:
■ Firmly secure the material to be cut using the machine’s
vise (adjustable flip fence, extension block, and vise
clamp).
■ Using the fence lock handle, loosen the fence assembly.
See Figures 14 and 15.
■ Rotate the adjustable fence to the angle needed.
■ Retighten fence lock handle.
WARNING:
To avoid serious personal injury, always tighten fence
lock handle securely before making a cut. Failure to do
so could result in movement of the workpiece while
making a cut.
■ Place the workpiece flat on the machine base with one
surface securely against the adjustable flip fence.
■ Align cutting line on the workpiece with the edge of the
abrasive wheel.
■ Push in the vise crank handle to set the vise clamp against
the workpiece. Turn the vise crank handle 1/2 to 1 turn
clockwise to securely clamp the workpiece to the fence.
WARNING:
To avoid serious personal injury, keep your hands at least
3 in. (76.2 mm) from wheel.
■ When cutting long pieces, support the opposite end of
the material with a roller stand or with a work surface
level with the machine base.
WARNING:
Never perform any cutting operation freehand (without
placing workpiece in the vise). Material will get hot during
cutting operation. Keep hands off of metal being cut to
avoid serious personal injury.
■ Before turning on machine, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.
■ Start the machine by grasping the handle and fully
squeezing the switch trigger. Allow several seconds for
the wheel to build up to full speed before letting it come
into contact with the material to be cut.
Fig. 14
Fig. 15
MACHINE
BASE
MACHINE ARM
(HANDLE)
SWITCH
TRIGGER
MATERIAL
TO BE CUT
EXTENSION
BLOCK
ADJUSTABLE
FLIP FENCE
VISE
CLAMP
0
15
30
45
FENCE
LOCK
HANDLE
MATERIAL
TO BE CUT
“C” CLAMP
AREA
VISE
CRANK
HANDLE
■ Once it reaches full speed slowly lower the handle of the
machine arm until the cut-off wheel comes in contact with
the material being cut. Continue to use steady and even
pressure to obtain a uniform cut through the workpiece.
Never force the wheel into the material being cut.
■ When the cut is complete, release the switch trigger and
allow the wheel to stop rotating before raising the wheel
out of workpiece.
WARNING:
Do not touch the cut material until it cools or you can be
burned. Failure to heed this warning could result in serious
personal injury.
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels