Page 16
MOUNTING HOLES
Your cut-off machine should be permanently mounted to a
firm supporting surface such as workbench. The four bolt
holes that secure the feet on the bottom of the base can be
used for this purpose. Using a 6 mm hex key, remove bolts,
washers, and feet from bottom of cut-off machine. The four
mounting holes should be bolted securely using 8 mm
machine bolts, lock washers, and flat washers (not in-
cluded). Bolts should be of sufficient length to accommodate
lock washers, flat washers, thickness of the workbench, and
sufficiently engage bolt hole threads in bottom of the base.
Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in
figure 16. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure workbench to the
floor before operating.
EXTENSION CORDS
The use of any extension cord will cause some loss of power.
To keep the loss to a minimum and to prevent tool
overheating, use an extension cord that is heavy enough to
carry the current the tool will draw.
A wire gage size (A.W.G.) of at least 14 is recommended for
an extension cord 25 feet or less in length. When working
outdoors, use an extension cord that is suitable for outdoor
use. The cord's jacket will be marked WA.
WARNING:
Keep extension cords away from the cutting area and
position the cord so that it will not get caught on materi-
als, tools, etc., during cutting operation.
WARNING:
Check extension cords before each use. If damaged,
replace immediately. Never use tool with a damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing dust.
If operation is dusty, also wear a dust mask.
MAINTENANCE
WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other part may create a hazard or cause
product damage.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use a clean cloth to remove dirt, carbon dust, etc.
CAUTION:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
OPERATION
Fig. 16
8 in.
17-1/8
7/16 in. DIA.
HOLE
HOLE PATTERN FOR MOUNTING SURFACE
WARNING:
Always make sure your cut-off machine is securely mounted to a workbench or an approved workstand. Failure to do so
could result in an accident resulting in possible serious personal injury.
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels