Ryobi C357 Manuel de l'opérateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Page 11
0
1
5
ADJUSTMENTS
Fig. 6
ADJUSTABLE FENCE
See Figure 6.
The adjustable fence is located at the rear of your cut-off
machine. As mentioned previously, it is used along with the
vise clamp to provide a clamp for holding your workpiece
securely when making cuts. It also makes your cut-off
machine more versatile.
The fence can be rotated to obtain cutting angles from 0° to
45°. It also can be moved back to allow greater cutting widths
in thin stock, or forward to allow greater cutting depths in tall
or thick stock.
CUTTING ANGLE ADJUSTMENT
See Figures 6 and 7.
Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
Using the 8 mm hex key supplied, loosen the two socket
head bolts securing adjustable fence.
See Figure 7.
Rotate fence until the desired angle of cut on the scale is
aligned with the indicator in machine base.
For precise cuts, check the angle of cut for the fence
against the abrasive wheel with a protractor, bevel square,
or other similar device.
Using the 8 mm hex key supplied, securely tighten socket
head bolts. Return hex key to its storage area in base.
This will secure the fence in place at desired angle.
See Figure 6.
ADJUSTING WIDTH OF CUT
See Figures 7 and 8.
Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
To increase the width of cut of your cut-off machine, use
the 8 mm hex key to loosen and remove the socket head
bolts and washers securing fence to machine base.
Reposition the curved slot of the fence with the threaded
hole in back of the machine base.
Install a socket head bolt through a lock washer and flat
washer into machine base. Do not tighten bolt securely.
Align remaining fence bolt hole with the middle threaded
hole in the machine base.
Install socket head bolt through lock washer and flat
washer into machine base.
Check and adjust fence to desired cutting angle.
Fig. 7
Fig. 8
ADJUSTABLE
FENCE
SCALE
INDICATOR
ADJUSTABLE
FENCE
FENCE
SCALE
VISE
CLAMP
SOCKET HEAD
BOLTS
SOCKET HEAD
BOLTS
ADJUSTABLE
FENCE
THREADED
HOLE
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Commentaires sur ces manuels

Pas de commentaire