Ryobi P742 Manuel d'utilisation et d'entretien télécharger pdf (Page 7)

7 — English

OPERATION

for that device or by using the radio’s VOL + or VOL –

button.

 Turning the radio off will NOT turn the phone/MP3 player

off.

 The auxiliary cable DOES NOT provide charging function.

 For complete operating instructions for the connected

device, always refer to the manual that was included with

your device.

USING A BLUETOOTH

ENABLED DEVICE

(NOT INCLUDED) WITH THE RADIO

See Figure 5, page 10.

Press the MODE button until the BLUETOOTH

mode

is highlighted.

When the radio is switched to BLUETOOTH

mode, the

unit will attempt to pair to a BLUETOOTH

enabled device

and “bt” will flash in the LCD display.

 NOTE: The radio will automatically attempt to connect to

the last device it was paired to. If a connection cannot be

established within five seconds, the radio will make itself

available to other BLUETOOTH

enabled devices.

BLUETOOTH

enabled devices must be within 30 ft. of

the radio and set to search/scan in order to pair with the

radio.

Select “RYOBI Radio” from your device’s list of available

BLUETOOTH

signals to pair the device and the radio.

No password or PIN is required for connection.

When the device has successfully paired with the radio,

“bt” will stop flashing.

NOTE: When a device is paired to the radio, informa-

tion for connecting to the device is saved in the radio’s

memory.

When streaming audio from a BLUETOOTH

enabled

device, press the SCAN left and right arrow buttons to

go to the previous or next track. Briefly press and release

the PRESET button to cycle between pausing and playing

the audio.

NOTE: These controls may not be supported by the

BLUETOOTH

device and/or application you are using.

All BLUETOOTH

enabled device controls can be used

normally while paired to the radio.

NOTE: Volume for any device paired to the radio can be

adjusted using the volume control for that device or by

using the radio’s VOL + or VOL – button.

To disconnect the BLUETOOTH

enabled device, press

and hold the PRESET button. When the device is discon-

nected, “bt” will begin flashing in the LCD display and the

radio will begin searching for another device.

USING THE USB DEDICATED CHARGING PORT

The USB dedicated charging port provides charging power

of 5 Volts DC at up to 1 Amp for your cell phone, MP3 player,

or other USB devices.

NOTICE:

Attempting to charge devices rated more than 1 Amp,

such as a tablet, could damage the USB dedicated charg-

ing port and/or the device.

Connect one end of a USB cable (not provided) to your

USB device.

Connect the other end of the USB cable (not provided) to

the USB dedicated charging port to begin charging the

device.

NOTE: The USB dedicated charging port provides

power only; it does not provide any data communication

capabilities.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi P742 Manuel d'utilisation et d'entretien Page 7

Commentaires sur ces manuels