Ryobi R163K Manuel d'utilisateur télécharger pdf (Page 12)

OPERATION

SELECTING DEPTH OF CUT

Proper depth of cut depends on several factors: the

horsepower of the router motor, the type of bit, and the type

of wood. A lightweight, low horsepower router is designed

for making shallow cuts; a router with higher horsepower is

designed for deeper cuts. Small bits, such as veining bits

with 1/16 in. cutting diameters, are designed to remove only

small amounts of wood. Large bits, such as straight-flute

bits, remove larger amounts of wood and make deeper cuts

in soft woods, such as white pine.

Choose a depth of cut that will not place excessive strain on

the router motor. If you need extra force or the motor speed

slows down considerably, turn off the router and reduce the

depth of cut. Then, make the cut in two or more passes.

When routing a groove that is too deep to safely cut in one

pass, make the cut in several passes. We recommend that

cuts be made at a depth not exceeding 1/8 in. and that

several passes be made to reach deeper cuts.

SETTING DEPTH OF CUT

See Figures 5 - 6.

The bit depth can be adjusted by turning the depth

adjustment knob clockwise or counterclockwise. The

depth of the cut can be read on the depth adjustment knob.

Each mark on the scale indicates a 1/128 in. change in

depth setting.

 Unplug the router.

 Loosen the lock lever.

 Turn the depth adjustment knob counterclockwise to

move the collet down or clockwise to move the collet

up.

NOTE: It should not be possible to make depth

adjustments with the lock lever tightened. If depth

adjustments are possible with the lock lever tightened,

an adjustment to the lock lever needs to be made. See

Adjustments.

 When the desired depth of cut is set, tighten the lock

lever.

To use the quick release button:

 Unplug the router.

 Loosen the lock lever.

 Press and hold the quick release button while moving the

router motor up or down in the base.

NOTE: It should not be possible to make depth

adjustments with the lock lever tightened. If depth

adjustments are possible with the lock lever tightened,

an adjustment to the lock lever needs to be made. See

Adjustments.

 When the desired depth of cut is set, tighten the lock

lever.

Fig. 6

Fig. 5

DEPTH

aDjuSTmENT

kNOb

DECrEaSE

DEPTH

INDICaTOr POINT

bIT

SCaLE

INCrEaSE

DEPTH

SLOT IN

SubbaSE

aDjuSTINg

NuT

T-HaNDLE WrENCH

DECrEaSE

DEPTH

INCrEaSE

DEPTH

LOOSEN

quICk

rELEaSE buTTON

LOCk

LEvEr

LOCk LEvEr

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi R163K Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi R163K