Ryobi RE180PL1 Manuel d'utilisateur télécharger pdf (Page 21)

MAINTENANCE

Fig. 24

BRUSH

CAP

BRUSH

ASSEMBLY

BRUSH

ASSEMBLY

BRUSH

CAP

LUBRICATION

All of the bearings in this tool are lubricated with a

sufficient amount of high grade lubricant for the life of the

unit under normal operating conditions. Therefore, no

further lubrication is required.

CUTTERS

Get faster and more accurate cutting results by keeping

cutters clean and sharp. Remove all accumulated pitch

and gum from cutters after each use.

When sharpening cutters, sharpen only the inside of the

cutting edge. Never grind the outside diameter. Be sure

when sharpening the end of a cutter to grind the clearance

angle the same as originally ground.

COLLET

Dust and chips may collect on the collet from time to

time, making it necessary to clean the collet. To do so,

remove the collet assembly and wipe it with a clean dry

rag. Clean the taper in the shaft in the same manner.

Never immerse the collet or end of the shaft in a solvent

or in water. Before replacing the collet assembly, put a

drop of SAE30 motor oil on the inside of the nut, on the

threads of the shaft, and on the taper in the shaft.

Replace the collet assembly onto the shaft by hand only.

Never tighten the collet nut without a bit in the collet. This

action could permanently damage the collet.

BRUSH ASSEMBLIES

See Figure 24.

Your router has externally accessible brush assemblies

that should periodically be checked for wear.

TO REPLACE BRUSH ASSEMBLIES

■ UNPLUG YOUR ROUTER.

WARNING:

Failure to unplug your router could result in acciden-

tal starting causing serious injury.

■ Remove brush cap with a screwdriver. Brush

assembly is spring loaded and will pop out when

you remove brush cap.

■ Remove brush assembly (brush and spring).

■ Check for wear. If worn, always replace in pairs.

Do not replace one side without replacing the other.

■ Reassemble using new brush assemblies. Make

sure curvature of brush matches curvature of motor

and that brush moves freely in brush tube.

■ Make sure brush cap is oriented correctly (straight)

and replace.

■ Tighten brush cap securely. Do not over torque.

1 2 ... 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi RE180PL1 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi RE180PL1