Ryobi Router Table A25RT02 Manuel d'utilisateur télécharger pdf (Page 12)

ASSEMBLY

PRE-DRILLING HOLES FOR THROUGH

TABLE DEPTH ADJUSTMENT

See Figure 8.

Since each router will have different placements for through

table depth adjustments, pilot holes have been pre-drilled in

the throat plate to assist in through table adjustments. Only

the models listed below in the key are available for use with

the through table depth adjustment feature.

 Remove the throat plate.

 Determine which router you have and find the pre-drilled

pilot hole that matches your router. (Refer to the key be-

low.)

 Using a drill and drill bit, drill a hole through the pilot hole

large enough for the depth adjustment tool (not included

with router table, but may be included with your router)

to pass though so through table depth adjustments can

be made.

Figure 8 Key:

RD: RIDGID R2930

RY: Ryobi R163K

ML: Milwaukee 5615-20, 5616-20

PC1: Porter-Cable 890 Series

PC2: Porter-Cable 8529

ATTACHING THE ROUTER TO THE TABLE

For ease of use, assemble the router to the insert plate with

the insert plate removed first, then install the insert plate/

router assembly into the router table.

ATTACHING THE ROUTER TO THE INSERT

PLATE

See Figures 9 - 10.

 Remove the insert plate.

 Remove the subbase plate from the router.

 Using the following chart for reference, and using one of

the three included sets of three router insert plate screws,

attach the router to the insert plate with the pilot holes

facing the router and the notch in the insert plate facing

the back of the router table.

NOTE: When attaching insert plate to the router, make

sure the holes in the router base match up with the insert

plate accurately and are not off-center.

INSTALLING THE ROUTER/INSERT PLATE

ASSEMBLY

See Figure 11.

 With the insert plate installed on the router, insert router

and insert plate assembly into the router table with the

notch in the insert plate facing the back of the router table

toward the fence assembly.

 Install the insert plate screws and leave loose until all

adjustments have been made.

Inch

FEED

DIRECTION

Fig. 10

Fig. 11

NOTCH

PC2

PC1

Fig. 8

Fig. 9

PRE-DRILLED

PILOT HOLES

INSERT PLATE

REAR SIDE

INSERT PLATE

FRONT SIDE

INSERT PLATE

ROUTER INSERT

PLATE SCREWS

INSERT PLATE

SCREWS

NOTCH

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi Router Table A25RT02 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi Router Table A25RT02