Ryobi Router Table A25RT02 Manuel d'utilisateur télécharger pdf (Page 17)

OPERATION

PERFORMING A ROUTING OPERATION

Observe the following rules when using the router.

 Read the entire operator’s manual for the router and

router table.

 Plug the router table power cord into a power source.

 Always control the power to the router with the router

table switch whenever the router is mounted on the

table.

 Always plug the router into either of the router table

switched outlets. Never plug a router table mounted

router into another power source.

 Position the infeed and outfeed fence so they are close

to the maximum diameter of the cutter, but not touching

the cutter.

NOTE: The workpiece must always be tight against

the fence, unless you are using a ball-bearing piloted

cutter.

 Adjust the infeed fence to support the uncut workpiece

and adjust the outfeed fence to support the workpiece

after the cut. The “0” location on the fence scale denotes

the center of the throat opening of the table.

 Reconfirm that all router adjustments are securely locked

before connecting the router table to a power source.

 Feed the workpiece from right to left with the cutter in

line with the fence opening.

 Make sure the router table switch is off when not in use.

Remove the switch key to ensure the router table is off.

WARNING:

Do not allow familiarity with products to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear safety goggles or safety glasses with side

shields when operating power tools. Failure to do so

could result in objects being thrown into your eyes

resulting in possible serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product. The

use of attachments or accessories not recommended

can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:

 �Table mounted dado and mortise operations in wood and

wood composition materials

 Fence guided edging operations for cabinetry and

picture framing on wood and wood composition

materials

 Piloted cutter operations using the starting pin for

edging patterned surfaces on wood and wood

composition materials

WARNING:

The direction of feed for the workpiece is always against

the sharp edges of the cutter and therefore into the rota-

tion of the cutter. Failure to heed this warning can result

in serious personal injury.

WARNING:

When operating the router with the router table, the

router must only be plugged into and controlled by the

router table switched outlet. To reduce the risk of serious

personal injury, never connect the table mounted router

into another power source.

WARNING:

The router or router table should never be connected to

a power supply when you are assembling parts, making

adjustments, installing or removing cutters, cleaning, or

when not in use. Disconnecting the router and router table

will prevent accidental starting that could cause serious

personal injury.

1 2 ... 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi Router Table A25RT02 Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi Router Table A25RT02