Ryobi Router Table A25RT02 Manuel d'utilisateur télécharger pdf (Page 18)

Inch

FEED

DIRECTION

FEED

DIRECTION

Inch

OPERATION

INSERTING/REMOVING CUTTERS

 Unplug the router table and/or the router.



Remove the router/insert plate assembly. (See Installing

Router/Insert Plate Assembly in the Assembly section.)

WARNING:

If you are changing a cutter immediately after use, be

careful not to touch the cutter or collet with your hands or

fingers. They will get burned because of the heat buildup

from cutting. Always use a wrench.

 Consult the router operator’s manual for proper cutter

removal/installation procedure and replace cutter.

ADJUSTING DEPTH OF CUT

We recommend that cuts be made at a depth not exceeding

1/8 in. and that several passes be made to reach depths of

cut greater than 1/8 in.

ADJUSTING THE MITER GAUGE

See Figure 21.

 Unplug the router table and/or the router.

 Loosen the miter gauge knob.

 Rotate the miter gauge to the desired angle.

 Tighten the miter gauge knob.

POSITIONING THE FENCE

See Figure 22.

The fence enables you to support and guide the work-

piece.

 Unplug the router table and/or the router.

 Loosen the fence lock knobs.

 Position the fence to the desired location.

 Tighten the fence lock knobs.

NOTE: The outfeed fence has joining capabilities and can

be adjusted out in increments up to 1/4 in. and enable

you to support the workpiece as it exits the cutter.

Fig. 21

MITER

GAUGE KNOB

MITER GAUGE

TIGHTEN

CUTTER

PROPER

DISTANCE

FENCE LOCK KNOBS

SCALE

OUTFEED FENCE

WARNING:

When making a side or edge cut, never position the fence

such that the workpiece is located between the cutter

and the fence. Failure to heed this warning can result in

serious personal injury.

LOOSEN

Fig. 22

1/4

SCALE

1 2 ... 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi Router Table A25RT02 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi Router Table A25RT02