Ryobi Router Table A25RT02 Manuel d'utilisateur télécharger pdf (Page 9)

FEATURES

RESET BUTTON

See Figure 2.

The router table switch is equipped with a reset button that

protects the electronic components of the router table switch

box from overload.

STARTING PIN

When you are unable to use the fence for a guide because

the workpiece is odd-shaped or too small, use the starting

pin for a guide and/or pivot point. Only use piloted cutters

when using the starting pin.

THROAT PLATES

Five throat plates are included with the router table. The

throat plate provides a stable surface around the cutter and

prevents objects from falling through the throat and damag-

ing the spindle.

VACUUM PORT

The vacuum ports molded into the fence will accept either

a 1-1/4 in. or 2-1/2 in. vacuum attachment.

SWITCH ASSEMBLY

See Figure 3.

This product is equipped with a switch assembly that has a

built-in locking feature. This feature is intended to prevent

unauthorized and possible hazardous use by children and

others.

TO TURN YOUR ROUTER TABLE ON:

 Plug the router into either switch box outlet on the router

table and plug the router table into a 120 volt grounded

outlet.

 With the switch key inserted into the switch, lift the switch

to turn ON ( l ).

NOTE: The router table is equipped with a reset button ( See

Figure 2 ). If, for any reason, the router table will not turn on,

press the reset button and then restart.

TO TURN YOUR ROUTER TABLE OFF:

 Press the switch down to turn OFF ( O ).

TO LOCK YOUR ROUTER TABLE:

 Press the switch down.

 Remove the switch key from the switch and store in a

safe, secure location.

Fig. 3

SWITCH KEY

SWITCH IN LOCKED POSITION

SWITCH

OFF

SWITCH

WARNING:

Always remove the switch key when the tool is not in

use and keep it in a safe place. In the event of a power

failure, turn the switch OFF ( O ) and remove the key.

This action will prevent the tool from accidentally starting

when power returns.

WARNING:

ALWAYS make sure your workpiece is not in contact with

the cutter before operating the switch to start the tool.

Failure to heed this warning may cause the workpiece to

be kicked back toward the operator and result in serious

personal injury.

WARNING:

To reduce the risk of accidental starting, ALWAYS make

sure the switch is in the OFF ( O ) position before plugging

tool into the power source.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi Router Table A25RT02 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi Router Table A25RT02